how to get to snap settings autocad for mac

It seems that Autodesk has disabled this feature by default, maybe because of performance issues.

You can do it by typing OP then enter or by accessing through AutoCAD ribbon.

Technical Consultant in Tech Data Advanced Solutions Indonesia.

Ive been using AutoCAD since R14 and Revit since Revit Building 9.

I occasionally write for AUGIWorld magazine and also active in Autodesk discussion forum.

Im an Autodesk Certified Professional (ACP) for Revit Architecture and AutoCAD.

Im also a member of Autodesk Expert Elite, appreciation for individuals who give contribution to Autodesk community.

With running object snap settings, also called Osnap, you can specify a snap point at an exact location on an object.

You cannot access the Application Preferences dialog box from the Drafting Settings dialog box if you are running DSETTINGS transparently.

The value must be a positive real number.

SNAPUNIT system variable).

The snap spacing intervals can be different from the grid spacing intervals.

If this value is 0, the PolarSnap distance assumes the value for Snap X Spacing.

The Polar Distance setting is used in conjunction with polar tracking andor object snap tracking.

If neither tracking feature is enabled, the Polar Distance setting has no effect.

POLARDIST system variable).

When you specify points, the cursor snaps along vertical or horizontal grid points.

SNAPTYPE system variable).

When the snap type is set to Grid snap and Snap mode is on, the cursor snaps to a rectangular snap grid.

SNAPSTYL system variable).

When the snap type is set to Grid snap and Snap mode is on, the cursor snaps to an isometric snap grid.

When Snap mode is on and you specify points with polar tracking turned on, the cursor snaps along polar alignment angles set on the Polar Tracking tab relative to the starting polar tracking point.

You can also turn grid mode on or off by clicking Grid on the status bar, by pressing Fn-F7, or by using the GRIDMODE system variable.

You can also set grid style by using the GRIDSTYLE system variable.

If this value is 0, the grid assumes the value set for Snap X Spacing.

GRIDUNIT system variable).

If this value is 0, the grid assumes the value set for Snap Y Spacing.

The frequency of these grid lines is determined by the frequency of the major grid lines.

GRIDDISPLAY and GRIDMAJOR system variables).

You can also turn polar tracking on or off by pressing F10 or by using the AUTOSNAP system variable.

You can enter any angle, or select a common angle of 90, 45, 30, 22.5, 18, 15, 10, or 5 degrees from the list.

POLARANG system variable).

The Additional Angles check box is also controlled by the POLARMODE system variable, and the list of additional angles is also controlled by the POLARADDANG system variable.

To remove existing angles, click Delete.

POLARADDANG system variable).

Up to 10 additional polar tracking alignment angles can be added.

For example, if the value of AUPREC is 0 (the default value), all fractional angles you enter are rounded to the nearest whole number.

When you use object snap tracking, the cursor tracks along polar alignment angles from acquired object snap points.

POLARMODE system variable).

How To Get To Snap Settings Autocad For Mac